Hey Man, what’s that cord for?
Today:
- All regulators installed and checked for voltage at jumpers
- Throttle potbox installed, connected to pedal by existing cable
- Control board reinstalled
- Low voltage components tested at key on (power steering motor, blower fan, vacuum pump)
- High voltage wiring complete to circuit breaker and contactors
- Broke stud on negative contactor (whoops)
- Installed PFC-30 charger
- Made 220V to 110V adapter
- Tested charger, all batteries show 13.2V at 10 amp draw
- Tested regulators – seemed ok, but the yellow leds didn’t act as I expected. Reviewing the manual to see what’s going on.
Tomorrow we hope to do a test run! Need to wire the negative contactor, circuit breaker, and low voltage wiring to the controller.