«
»

Battery Regulator Wiring

I worked a little more on the new wiring for the battery regulators.

Here are the regulators mounted on the metal rods. Behind is the junction box they fit in.

Here are the regulators mounted on the metal rods. Behind is the junction box they fit in.

These are the wire ends that attach to the regulators. I intended to strip out the green wire but it looks like the 3 wires are spiraled so it would be too difficult. I couldn't find 12/2 with other than extension cord and I didn't like the look of that.

These are the wire ends that attach to the regulators. I intended to strip out the green wire but it looks like the 3 wires are spiraled so it would be too difficult. I couldn't find 12/2 with other than extension cord and I didn't like the look of that.

These are the 8 wires that connect to the rear regulator rack. Crimped, soldered and wrapped.

These are the 8 wires that connect to the rear regulator rack. Crimped, soldered and wrapped.

The rack inside the junction box with a wire running down the side. All 8 will enter the box through the top. I still need to add a bar on the right side to keep the wires from putting stress on the top regulator. It will be a thin metal strip across the threaded rods.

The rack inside the junction box with a wire running down the side. All 8 will enter the box through the top. I still need to add a bar on the right side to keep the wires from putting stress on the top regulator. It will be a thin metal strip across the threaded rods.

This is the top where the 8 wires will exit the junction box and continue to the rear battery pack.

This is the top where the 8 wires will exit the junction box and continue to the rear battery pack.

Tags: , ,

This entry was posted on Tuesday, March 23rd, 2010 at 9:47 pm and is filed under doing. You can follow any responses to this entry through the RSS 2.0 feed. Both comments and pings are currently closed.

Comments are closed.